+
  • 1(1720505712317).jpg

Step Ring for Rod GSJ

The piston rod has a one-way actuation seal ring consisting of an anti-wear filled PTFE ring and an O-ring rubber seal ring. The O-ring provides elasticity, compensates for the wear on the PTFE step rings, and has a one-way sealing effect.

subcategory:

Seal for Piston Rod

Product accessories:


Contact us

Product description

 

   1.Features
The piston rod has a one-way actuation seal ring consisting of an anti-wear filled PTFE ring and an O-ring rubber seal ring. The O-ring provides elasticity, compensates for the wear on the PTFE step rings, and has a one-way sealing effect. Suitable for sealing the piston rod of a hydraulic cylinder. A guide ring is generally used. If the axle diameter is less than φ30, the split groove shall be adopted. 
   2.Materials

The wear ring is made of PTFE bronze composite; 

The O-ring is Nitrile Butadiene Rubber (NBR); or Fluororubber (FKM).

   3.Performance

The step ring for the rod resistance GSJ is suitable for a single side-pressure piston rod; 

Very high pressure stability under pressure and harsh conditions ;

or Fluororubber (FKM);

Good thermal conductivity;

Very good reliability against extrusion ;

High wear resistance;

Low friction, no stick-slip phenomenon.

   4.Operating Conditions

Pressure: ≤40MPa;

Speed: ≤5m/s;

Frequency: ≤5Hz;

Temperature: -30°C to +200°C (depends on the material of the O-ring);

Medium: mineral-based hydraulic oil, flame retardant liquid (HFA, HFB), biodegradable hydraulic oil, water.

5.Groove Surface Quality

 

 

6.Installation